Spin the heavy material out first
A cyclone separator removes particles from air by spinning it. There is no filter media to load or replace, so cyclones handle heavy loads of coarse, abrasive material that would quickly wear or blind a filter. They work well on their own for coarse material and as a first stage in front of a fabric filter.
Capacities are selected to your load. Ask for a datasheet.
How it works
Dusty air enters the top of the cyclone tangentially and spirals downwards around the inside of the body. Centrifugal force throws heavier particles against the wall, where they slide down the cone and discharge through a valve at the bottom. The air reverses direction at the bottom of the cone and leaves up through a central outlet. Coarse particles separate efficiently; fine dust follows the air, which is why a filter usually follows where fine dust or emissions limits matter.
Where it fits
- Wood processing: chips, sawdust and shavings.
- Rice mills: husk and bran.
- Pre-separation ahead of bag filters and cartridge collectors.
- Material recovery at the end of pneumatic conveying lines.
Selection notes
- Particle size decides efficiency. Cyclones separate coarse material well and fine dust poorly. We check the particle size range of your material before deciding whether a cyclone alone is enough.
- Pressure drop and fan. Higher efficiency designs usually have higher pressure drop. The fan is sized for the whole system.
- Discharge seal. A leaking discharge valve lets air in at the bottom and re-entrains collected dust. Rotary valves or airlocks keep it sealed.
- Wear. Abrasive dusts wear the inlet and cone. Wear-resistant liners can extend life.
- Combustible material. Wood and agricultural dusts can be combustible. The whole system is assessed for explosion risk.
What Nexus provides
Material and dust assessment, cyclone and fan selection, ductwork and discharge design, installation and commissioning, and maintenance including wear inspection.