Phnom Penh, serving Cambodia and the region

Glossary

Ring main

A compressed air distribution header laid as a closed loop, so air reaches each take-off from two directions with lower pressure loss.

A ring main is a distribution header that forms a closed loop around the production area. Air can flow to any drop from both sides, so the velocity in each leg, and the pressure drop, is lower than in a single dead-end line of the same size.

Dead-end mains that grew with the factory are a common cause of low pressure at the far machines, which plants then “fix” by raising compressor pressure for everyone. A properly sized loop lets the whole hall run at a lower set point.

Practical note: good practice is to take drops from the top of the header so condensate stays in the main, lay the main with a slight fall towards drain points, fit isolation valves so sections can be worked on without shutting the plant, and size for planned expansion.

Next step

Need this applied to your plant?

We turn definitions into specifications, then into equipment that meets them.

Start typing to search