Humidity control that stays off the floor
In many rooms the floor is the most valuable space: production lines, racking, benches and cleaning routes. A ceiling-mounted dehumidifier controls humidity from above, either suspended below the ceiling or installed in a ceiling void with a short duct or grille. The floor stays clear and cleaning is easier.
AirMax ceiling-mounted units are refrigerant dehumidifiers designed for overhead installation. Capacities are selected to your load. Ask for a datasheet.
How it works
The unit draws room air through a filter and across a cold evaporator coil. Moisture condenses below the air’s dew point and is drained by gravity or, where the drain route rises, by a condensate pump. The dried air is reheated over the condenser and discharged back into the room through a grille or short duct. A wall-mounted or remote sensor controls the unit to the target relative humidity.
Where it fits
- Production and packing rooms with no spare floor space.
- Racked stores, archives and records rooms.
- Laboratories and quality-control rooms.
- Clean workrooms where floor-standing units collect dust.
Selection notes
- Structure and access. The ceiling or roof structure must carry the unit, and maintenance staff need safe access to filters, coils and drains. We plan both at design stage.
- Drain routing. Overhead condensate lines need a reliable fall or a pump with an alarm. A leaking drain over product or equipment is the failure to design out.
- Air distribution. Discharge direction and grille positions decide how evenly the room is dried. For larger or divided areas, a ducted unit may serve better.
- Load first. As with every dehumidifier, the moisture load sets the capacity: outside air, infiltration, people and process. In the monsoon season that load peaks.
What Nexus provides
As technology partner and authorised distributor for AirMax, we calculate the load, check structure and access, design drain routes and controls, install and commission the units, and verify humidity at handover. Planned maintenance covers filters, coils, drains and pumps.