Phnom Penh, serving Cambodia and the region

AirMaxDesiccant wheel dehumidifier

AirMax desiccant rotor dehumidifiers

Desiccant rotor dehumidifiers for low humidity targets and cool spaces, where refrigerant coils stop working well.

Spec summary

At a glance

TypeDesiccant wheel dehumidifier

Capacities selected to your load. Ask for a datasheet.

Key features

  • Rotating desiccant wheel adsorbs water vapour from process air
  • Separate heated reactivation air stream carries moisture outside
  • Effective at low humidity targets and low temperatures
  • No condensate drain: moisture leaves as warm, wet exhaust
  • Ducted installation with supply, return and reactivation connections
  • Can be combined with cooling coils for temperature and humidity control

Applications

  • Pharmaceutical production and storage with low humidity targets
  • Hygroscopic powders, capsules and tablets
  • Electronics and battery assembly
  • Cold stores and chilled areas
  • Food processes sensitive to moisture

Dry air where a cold coil cannot reach

A refrigerant dehumidifier can only remove water down to the temperature of its coil. For low humidity targets, or in cool rooms, it runs out of ability: the coil would need to be below freezing. A desiccant rotor dehumidifier works differently. It adsorbs water vapour directly from the air, so it keeps drying at low humidity and low temperature.

AirMax desiccant rotor dehumidifiers are designed for these duties. Capacities are selected to your load. Ask for a datasheet.

How it works

A slowly turning wheel, made of a honeycomb impregnated with desiccant, sits across two air streams. The process air passes through most of the wheel face, where the desiccant adsorbs water vapour and the air leaves dry. A smaller sector of the wheel is swept by reactivation air, heated so it drives the water back out of the desiccant. That warm, wet air is ducted outside. As the wheel turns, each part of it alternately adsorbs and is regenerated, so drying is continuous.

Because the water leaves as vapour in the reactivation exhaust, there is no condensate drain. The heat used for reactivation is the main running cost.

Where it fits

  • Pharmaceutical areas handling hygroscopic powders, capsules and tablets.
  • Electronics and battery assembly.
  • Cold stores and chilled production areas.
  • Food processes where moisture causes caking or spoilage.

Our article on humidity control in pharmaceutical and food plants covers typical targets and system arrangements.

Selection notes

  • Combine with cooling. Desiccant drying warms the air. Where temperature also matters, a cooling coil after the rotor, or a refrigerant pre-cooling stage before it, gives control of both. We design the combination around the target condition.
  • Reactivation energy. Electric, steam, gas or recovered heat can drive reactivation. The choice affects running cost. Where waste heat is available, we look at using it.
  • Room integrity. Low humidity targets are hard to hold in leaky rooms. Sealing and slight positive pressure reduce infiltration.
  • Pre-filtration. Dust shortens rotor life. Filters on both air streams protect it.

What Nexus provides

As technology partner and authorised distributor for AirMax, we calculate the load at the target condition, design the system with ductwork, cooling and controls, install and commission it, verify the condition at handover, and maintain the rotor, seals, heaters and filters.

Next step

Request a quote for AirMax desiccant rotor dehumidifiers

Send your operating data and we will size and propose the right configuration.

Start typing to search