Oil-flooded screw air for general industrial duty
The RM Series is part of Ingersoll Rand’s oil-flooded rotary screw line-up for general industrial compressed air. Like the rest of that line, it is designed for continuous running in production plants, with the airend, cooling, separation and controls integrated in one package.
Ingersoll Rand configures its ranges differently for different markets. Ask us which series are currently supplied in Cambodia, and we will confirm the current RM Series sizes, drive options and datasheets for your duty.
How it works
An oil-flooded screw compressor traps air between two meshing helical rotors and reduces its volume as they turn. Injected oil seals the rotor clearances, lubricates the bearings and absorbs the heat of compression. A separator removes the oil before the air leaves the package, and the oil returns through a cooler and filter. Discharge air is warm and saturated with water vapour, so an aftercooler, dryer and filters follow before the air reaches users.
Where it fits
- General plant air. Production machines, tools, blow-off and actuators.
- Base load or standby. A machine that runs loaded through the shift, or that waits as the N+1 standby.
- Replacement. Taking over from an older compressor at the end of its life, often alongside a VSD trim machine that handles the swings.
Selection notes
- Measure before you replace. Replacing a compressor with the same size can repeat an old mistake. A week of logged demand shows the real base load, peaks and leaks.
- Base and trim. A fixed-speed machine is efficient when it runs loaded. If demand varies widely, pair it with a VSD or PM-VSD trim compressor, or consider the R-Series VSD versions.
- Room and heat. Check the rated maximum ambient against your compressor room, and duct hot air out.
- Treatment. Size the dryer and filters for hot, humid inlet conditions.
What Nexus provides
As an authorised distributor of Ingersoll Rand, we select the machine against measured demand, design the room, piping and electrics, install and commission it, and support it with genuine parts, planned servicing and maintenance contracts. Where the RM Series joins an existing hall, we add it to the sequencing so old and new machines run as one system.
