A compressor that slows down when the plant does
Sollant builds its range around permanent-magnet variable-speed (PM-VSD) screw technology. A PM-VSD compressor drives an oil-injected rotary screw airend with a permanent-magnet motor through a variable-speed drive. When demand falls, the motor slows and power falls with it. A fixed-speed machine in the same situation alternates between loaded and unloaded running, and unloaded power buys no air.
Ask us which series are currently supplied in Cambodia. The indicative power span above is to be confirmed against current Sollant datasheets.
How it works
The controller compares discharge pressure with the setpoint and adjusts motor speed to hold it. Because speed tracks demand continuously, pressure stays within a narrow band. A narrow band lets the plant run at a lower setpoint, and the US Department of Energy’s rule of thumb is that each 2 psi of extra discharge pressure costs roughly 1 % of compressor energy around the 100 psig range. Permanent-magnet motors are compact and keep their efficiency well across the speed range.
Where it fits
- Variable demand. Single-shift plants, batch processes and lines that stop and start.
- Trim duty. One PM-VSD machine trimming alongside fixed-speed base-load compressors, under a sequencer.
- Retrofits. Replacing an older load/unload compressor where logged data shows long unloaded hours.
It is less compelling on a flat, fully loaded duty, where a fixed-speed machine runs at its best point anyway. See our comparison of fixed-speed, VSD and PM-VSD compressors.
Selection notes
- Size the turndown to the demand. A variable-speed machine has a minimum speed. If it is oversized, it spends its time there or stops and starts. We size from logged demand so the normal operating range sits inside the machine’s best band.
- Cooling the drive. Drives and motors need cool air in a hot room. Ventilation is part of the design.
- Power quality. We review supply and protection as part of the electrical design.
What Nexus provides
Demand logging and selection, room and electrical design, installation and commissioning, sequencing with your existing compressors, and support with genuine Sollant parts and maintenance contracts. Savings are project-specific. We measure them against a baseline and verify them after implementation; we don’t promise a blanket percentage.
